This page allows you to install the latest replacement firmware for the IPSTube clock (such as the H401) only.
Installation
With this clock you must put it in boot mode before installing the firmware. To do this:
- Unplug the clock
- Hold the button at the back down and plug it back in to the computer
Click the appropriate button below to install the latest version of the replacement firmware (it is recommended that you unplug other USB devices from your computer just to be safe). You will see a dialog box showing you the various USB ports, select the one that your clock is connected to.
After the firmware has installed you will need to unplug the clock and plug it back in again, then you can configure the wifi connection using the button at the bottom of the page (or you can use the access point the clock will create if you prefer).
You will see a dialog box showing you the various USB ports, select the one that your clock is connected to.
Full Install
If this is the first time you have installed v1.6.5 or above, choose this option. If you choose to erase the clock when prompted, you will lose any WiFi settings too (see below for how to connect to WiFi).
Firmware Only
If you have installed v1.6.5 or above before, you can choose this option, your files and settings will remain unchanged. DO NOT CHOOSE TO ERASE THE CLOCK WHEN GIVEN THAT OPTION. If you do you will have to do the full install again
Configure Wifi
Use the following button to just configure wifi without flashing: