This page allows you to install the latest firmware for Bambu Lights – a reactive lighting system for Bambu 3D printers, that uses 5V WS2812B LED strips. The code runs on an ESP32 – I used an ESP32 Pico D4 Devkit.
Full details of this project can be found on the github repository.
Installation
Connect your ESP32 board to this computer then click the appropriate button below to install the latest version of the firmware (it is recommended that you unplug other USB devices from your computer just to be safe). This will also allow you to configure the WiFi settings for the device (or you can use the access point the clock will create if you prefer).
You will see a dialog box showing you the various USB ports, select the one that your clock is connected to.
Full Install
Click the button below. If you choose to erase the clock when prompted, you will lose any WiFi settings too.
Configure Wifi
Use the following button to just configure wifi without flashing:
Hi, been going around with your repo and its amazing! I really love it and it seems very complete.
Managed to installed it and configure it via .local site. Unfortunately i wasnt able to make light respond once i had everything set up as im using several ESP32 boards that are not specifically the PICO 4.
Is there a way to address the Data pin # for ESP32S , maybe D1 or similar boards other than Pico 4?
Last but not least, thanks a lot for your work, its truly amazing.